User manual

Dynamix UM-SB Series User Manual V0.06
107
>>
user
Manage user profile
security
Setup system security
snmp
Configure SNMP parameter
passwd
Change supervisor password
id
Change supervisor ID
sntp
Configure time synchronization
5
5
.
.
9
9
.
.
1
1
U
U
s
s
e
e
r
r
P
P
r
r
o
o
f
f
i
i
l
l
e
e
You can use user command to clear, modify and list the user profile. You can setup at most five
users to access the router via console port or telnet in user profile table however users who have
the supervisor password can change the configuration of the router. Move the cursor “ >> “ to user
and press enter key.
>>
clear
Clear user profile
modify
Modify the user profile
list
List the user profile
You can delete the user by number using clear command. If you do not make sure the number of
user, you can use list command to check it. Modify command is to modify an old user information
or add a new user to user profile.
To modify or add a new user, move the cursor to modify and press enter.
----------------------------------------------------------------------
Command: admin user modify <1~5> <more...>
Message: Please input the following information.
Legal access user profile number <1~5> : 2
----------------------------------------------------------------------
The screen will prompt as follow.
>>
Attrib
UI mode
Profile
User name and password
There are two UI mode, command and menu mode, to setup the router. We will not discuss
command mode in this manual.
Move the cursor to Attrib to change the UI mode on this profile
Move the cursor to Profile and press enter, you can change the username and their password on
this profile.
The screen will prompt as follow:
------------------------------------------------------------------------
Command: admin user modify 5 profile <name> <pass_conf>
Message: Please input the following information.
Legal user name (ENTER for default) <admin>: superman
Input the old Access password: ****