User manual

Dynamix UM-SB Series User Manual V0.06
100
utility
Upgrade software and backup and restore configuration.
exit
Quit system.
5
5
.
.
4
4
S
S
t
t
a
a
t
t
u
u
s
s
You can view running system status of SHDSL.bis, WAN, route, interface, fireware, ip_qos and stp
via status command.
Move cursor “ >> “ to status and press enter.
>>
shdsl.bis
Show SHDSL.bis status
wan
Show WAN interface status
route
Show routing table
interface
firewall
ip_qos
Show interface statistics status
Show firewall status
Show IP QoS statistics
stp
clear
Show STP status
Reset statistics`
Command
Description
shdsl.bis
The SHDSL.bis status includes line rate, SNR margin, TX power, attenuation,
and CRC error of the product, and SNR margin, attenuation and CRC error of
remote side. The router can access remote side’s information via EOC
(embedded operation channel).
wan
WAN status shows all their parameters including IP address ,Net mask, PVC
and protocol information
route
You can see the routing table via route command.
interface
The statistic status of WAN and LAN interface can be monitor by interface
command.
firewall Show firewall status ( for firewall models only)
Ip_qos
Show IP QOS status
stp Show the STP status on all LANs and WANs
clear
Clear all statistics data
5
5
.
.
4
4
.
.
1
1
S
S
h
h
d
d
s
s
l
l
.
.
b
b
i
i
s
s
Move cursor “ >> “ to shdsl.bis and press enter.
If the Router is four wires model, there will show two channel’s status as the following:
-----------------------------------------------------------------------------
Monitoring Window...
<SHDSL.bis Status>