User manual

DynamixUM‐SNBUserManualVer1.0086
The next block down is the "command" section. The command that is selected and ready for execution is displayed after the
"Command:" prompt. The "<more…> designation indicates that there are other sub menus for this command. The
"Message:" field is used to display any special system messages or warnings.
Finally, at the very bottom of the screen is a help command line and reminder of the currently available command keys. In
most cases, the keyboards four cursor keys can be used to navigate all the menu system. If for some reason your
keyboard's cursor keys are not supported in the terminal emulation software, you may use the keys listed on the help
command line.
Menu Commands
Before changing the configuration, familiarize yourself with the operations listed in the following table. The operation list will be
shown on the window.
Keypads Description
[UP] or I Move to above field in the same level menu
[DOWN] or K Move to below field in the same lever menu
U Move to top field in the same level menu
O Move to bottom field in the same level menu
[LEFT] or J Move back to previous menu (Exit)
[RIGHT] , L or [ENTER] Move forward to submenu(Enter)
[TAB] To choose another parameters
Ctrl + C To quit the show data display screen