User manual

DynamixUM‐SNBUserManualVer1.0047
3.5.6. Application of STU-R configuration follow STU-C
Some configurations on STU-R side can follow STU-C side after DSL link up is finish.
Such that on STU-R side, you do not care about the settings of the E1 channel/slot number/first slot, serial data rate or Ethernet
data rate. When the DSL link up is finished, these configurations will follow the STU-C side.
STU-R STU-C
STU-R STU-C
STU-R STU-C
`
STU-R STU-C
# If STU-C is as T1 interface and set T1 channel is unframed mode, STU-R cannot follow.
# When E1/T1 model time slot and Serial/Ethernet model date rate set 1 of 2 on STU-C side, STU-R cannot follow.
# For the application on multi-interface, this function is not available. User must setup the configuration for both as the same
time before DSL link.
E1Interface
E1Channel
E1SlotNumber
E1FirstSlot
SerialInterface
SerialDataRate
EthernetInterface
EthernetDataRate
E1Interface
E1Channel
E1SlotNumber
E1FirstSlot
SerialInterface
SerialDataRate
EthernetInterface
EthernetDataRate
T1Interface
T1Channel
T1SlotNumber
T1FirstSlot
T1Interface
T1Channel
T1SlotNumber
T1FirstSlot