User manual

DynamixUM‐SNBUserManualVer1.00106
Setup Serial Parameter, DSR
The behavior of the DSR (Data Set Ready) signal may be set in one of three ways. When set 'on', the DSR signal is always
forced on (active low), when set 'off' the signal is always forced off or DSR will follow DTR (Data Terminal Ready) condition of
'on' for DTR on or 'off' for DTR off. The default setting for DSR is on.
Setup Serial Parameter, DCD
The behavior of the DCD (Data Carrier Detect) signal may be set in one of three ways. When set 'on', the DCD signal is always
forced on (active low), when set 'off' the signal is always forced off, or DCD will follow the DSL condition of 'on' for DSL link or
'off' for no link. The default setting for DCD is to follow the DSL link status.