User manual

DynamixUM‐SNBUserManualVer1.00103
5.4.4. Configure Serial parameters
When using the Serial interface, select the Serial item and press [ENTER] or [RIGHT].
The serial settings include the data rate, clocking and handshaking lines setup.
Setup Serial Parameter, Interface
There are two interfaces : V.35 and X.21.
Setup Serial Parameter, Data Rate - Rate type
There are two modes: Nx64K model and T1 mode. When other side as T1 interface and unframed mode connect to this side as
Serial interface, we must set Serial rate mode as T1 mode.