User manual

Dynamix UM-SE G.SHDSL.bis EFM Bridge Modem User Manual V003 92
User interface (TAB Select) <Menu>:
-----------------------------------------------------------------------------
There are two UI mode, command and menu mode, to setup the EFM modem.
The menu is meaning menu driven interface mode and Command is meaning line command
mode. We will not discuss command mode in this manual.
Move the cursor “>>” to profile and press enter.
-----------------------------------------------------------------------------
Command: admin user modify 2 profile <name> <pass_conf>
Message: Please input the following information.
Legal user name (ENTER for default) <test>:
Input the old Access password: ****
Input the new Access password: ****
Re-type Access password: *****
-----------------------------------------------------------------------------
Input the user name and setup the new access password. The new assess password must key
in two times for your confirmation.
Finally, you can use list command to check the listing of five profiles including on user name
and their UI mode. On next time you re-enter this system, you can use this set of username
and password. You can set up maximum to five profiles such that five sets of username and
their password.
User Profile:
User profile User name Password Attrib
1
□Menu □Command
2
□Menu □Command
3
□Menu □Command
4
□Menu □Command
5
□Menu □Command
4.10.2 Security
Security command can be configured sixteen legal IP address for telnet access and telnet port
number.
Move the cursor “ >> “ to security and press enter.
>> port Configure telnet TCP port
ip_pool Legal address IP address pool
list Show security profile
4.10.2.1 Telnet TCP port
User can set up the telnet TCP port from 1 to 65534. The default port is 23.