User manual

Dynamix UM-SE G.SHDSL.bis EFM Bridge Modem User Manual V003 55
3.7.2.1 Community Pool
An SNMP community is the group that devices and management stations runing SNMP belong
to. It helps define where information is sent. The community name is used to identify the
group. A SNMP device or agent may belog to more than one community. It will not requests
from management stations that do not belong to one of its communities.
SNMP default communities are:
Access Right Community
Read public
Write private
Press Modify to set up community pool.
In the table of current community pool, you can setup the access authority.
Status: Enable for turn on the SNMP function
Disable for turn off the SNMP function
Access Right: Deny for deny all access
Read for access read only
Write for access read and write.
Community: It serves as password for access right.
After configuring the community pool, press Finish.
The browser will prompt the configured parameters and check it before writing into NVRAM.
Press Restart to restart the EFM modem working with the new parameters and press Continue
to setup other parameters.
3.7.2.2 Trap Host Pool
In the table of current trap host pool, you can setup the trap host.
SNMP trap is an informational message sent from an SNMP agent to a manager. It is a
management station (SNMP application) that receives traps.