User manual

Dynamix UM-SE G.SHDSL.bis EFM Bridge Modem User Manual V003 19
3.4.1 Operation mode and MGMT
Click Basic for basic installation.
Click CPE (Customer Premises Equipment) side or CO (Central Office) side to setup the
operation mode. When connection with EFM DSLAM, the SHDSL.bis EFM modem’s working
mode is CPE. When “LAN to LAN” connection, one side must be CO and the other side must
be CPE.
Enter Parameters in MGMT item.
The EFM modem needs an IP address for it to be managed over the network. The factory
default IP address is 192.168.1.1. The subnet mask specifies the network number portion of an
IP address. The factory default subnet mask is 255.255.255.0 . You can configure another IP
address in a different Subnet Mask for management purposes.
IP: 192.168.1.1
Subnet Mask: 255.255.255.0
Host Name: SOHO
Some of the ISP requires the Host Name as identification. You may check with ISP to see if
your Internet service has been configured with a host name. In most cases, this field can be
ignored.
And than click Trigger DHCP service is Disable or Server. If you don’t need the DHCP service,
please click Disable.