User manual

G.shdsl Router User Manual 152
96
----------------------------------------------------------------------
Command: setup ip_share pat modify <1~10>
Message: Please input the following information.
Virtual server entry number <1~10>: 1
----------------------------------------------------------------------
After key in enter, the screen will prompt as below.
>> interface Active interface
port TCP/UDP port number
server Host IP address and port number
protocol Transport protocol
name Service name
begin The schedule of beginning time
end The schedule of ending time
Set the active interface number via
interface
command.
You can configure the global port number by using
port
command.
The local server, host, IP address and port number are configured via
server
command.
The authorized access protocol is setup via protocol command.
Name
command can be used to configure the service name of the host server.
Begin
and
end
command is used to setup the local server schedule to access.
You can view the fixed NAT mapping entry via
list
command.
DMZ
To setup demilitarized zone, move the cursor “>>” to
dmz
and press enter.
>> active Tigger DMZ host function
address Configure virtual IP address and interface
You can enable the demilitarized zone via
active
command.