User manual

G.shdsl Router User Manual 152
92
network.
You can setup 20 sets of static route in static command. After entering
static
menu, the screen will
show as follow:
>> add Add static route entry
delete Delete static route entry
list Show static routing table
You can add 20 sets of static route entry by using
add
command. Type the IP information of the
static route including IP address, subnet mask and gateway.
You can delete the static route information via
delete
command.
You can review the static route entry by using list command.
To configure Routing Information Protocol (RIP), you can use rip command to setup the
parameters. Move the cursor “
>>
” to
rip
and press enter.
>> generic Configure operation and auto summery mode
lan Configure LAN interface RIP parameters
wan Configure WAN interface RIP parameters
list Show RIP configuration
Generic
command can setup RIP mode and auto summery mode.
If there are any routers in your LAN, you can configure LAN interface RIP parameters via
lan
command.
The product supports 8 PVCs and you can configure the RIP parameters of each WAN via
wan
command. Move the cursor “
>>
” to
wan
and press enter.
----------------------------------------------------------------------
Command: setup route rip wan <1~8> <more...>
Message: Please input the following information.
Active interface number <1~8>: 1
----------------------------------------------------------------------
The screen will prompt as follow:
>> attrib Operation, authentication and Poison reverse mode
version RIP protocol version
authe Authentication code