User manual

G.shdsl Router User Manual 152

Clear command can clear CRC error count.

Generally, you cannot need to change SNR margin, which range is from 0 to 10. SNR margin is an

index of line connection. You can see the actual SNR margin in STATUS SHDSL. The larger SNR

margin, the better line connection. If you set SNR margin in the field as 2, the SHDSL connection

will drop and reconnect when the SNR margin is lower than 2. On the other hand, the device will

reduce the line rate and reconnect for better line connection.

WAN

The router supports 8 PVC, private virtual circuit, and so you can setup eight WAN, WAN1 to

WAN8. Move the cursor “

“ to

wan

and press enter. To setup WAN1, type

----------------------------------------------------------------------

Command: setup wan <1~8>

Message: Please input the following information.

Interface number <1~8>: 1

----------------------------------------------------------------------

protocol Link type protocol

address IP address and subnet mask

vpi_vci Configure VPI/VCI value

encap Configure encapsulation type

qos Configure VC QoS

isp Configure account name, password and idle time

ip_type Configure IP type in PPPoA and PPPoE

list WAN interface configuration

There are four types of protocols, IPoA, EoA, PPPoA and PPPoE, which you can setup.

For dynamic IP of PPPoA and PPPoE, you do not need to setup IP address and subnet mask.

There is an unique VPI and VCI value for Internet connection supported by ISP. The range of VIP

is from 0 to 255 and VCI from 0 to 65535.

There are two types of encapsulation types, VC-Mux and LLC.

You can setup virtual circuit quality of service, VC QoS, using qos command. The product supports

UBR, CBR, VBR-rt and VBR-nrt. The peak cell rate can be configured from 64kbps to 2400kbps.

Move the cursor to qos and press enter.

class Configure QoS class

pcr Configure peak cell rate (kbps)

scr Configure sustainable cell rate (kbps)

mbs Configure max. burst size (cell)