User manual

G.shdsl Router User Manual 152
87
Setup
All of the setup parameters are located in the subdirectories of setup. Move the cursor “
>>
“ to
setup
and press enter.
>> mode Switch system operation mode
shdsl Configure SHDSL parameters
wan Configure WAN interface profile
bridge Configure transparent bridging
vlan Configure virtual LAN paramters
route Configure routing parameters
lan Configure LAN interface profile
ip_share Configure NAT/PAT parameters
firewall Configure Firewall parameters
dhcp Configure DHCP parameters
dns_proxy Configure DNS proxy parameters
hostname Configure local host name
default Restore factory default setting
Mode
The product can act as routing mode or bridging mode. The default setting is routing mode. You
can change the system operation mode by using mode command. Move the cursor “
>>
“ to
mode
and press enter.
----------------------------------------------------------------------
Command: setup mode <Route|Bridge>
Message: Please input the following information.
System operation mode (TAB select) <Route>: Route
----------------------------------------------------------------------
SHDSL
You can setup the SHDSL parameters by the command shdsl. Move the cursor “ >> “ to shdsl and
press enter.
>> mode Configure SHDSL mode
Link Configure SHDSL link
n*64 Configure SHDSL data rate
type Configure SHDSL annex type
clear Clear current CRC error count
margin Configure SHDSL SNR margin
There are two types of SHDSL mode, STU-R and STU-C. STU-R means the terminal of central
office and STU-C customer premises equipment.
Link type will be 2-wire or 4-wire mode according to the product. 4-wire product can be worked
under 2-wire mode.
You can setup the data rate by the multiple of 64Kbps where n is from 0 to 32. If you configure n is
0, the product will perform as adaptive mode.
There are two types of SHDSL Annex type, Annex-A and Annex-B.