User manual

G.shdsl Router User Manual 152
18
Rear Panel
The rear panel of SHDSL router is where all of the connections are made.
DC-IN
LAN
CONSOLE
1 2 3 4
LINE
DC-INLAN
CONSOLE
LINE
Rear Panel of SHDSL 4-wire/4-port router/bridge
Rear Panel of SHDSL 2-wire/1-port router/bridge
RST
RST
Connectors Description of 2-wire/1-port router
DC-IN Power adaptor inlet: Input voltage 9VDC
LAN Ethernet 10BaseT for LAN port (RJ-45)
CONSOLE RS- 232C (DB9) for system configuration and maintenance
LINE SHDSL interface for WAN port (RJ-11)
RST Reset button for reboot or load factory default
Connectors Description of 4-wire/4-port router
DC-IN Power adaptor inlet: Input voltage 9VDC
LAN (1,2,3,4) 10/100BaseT auto-sensing and auto- MDIX for LAN port (RJ-45)
CONSOLE RS- 232C (DB9) for system configuration and maintenance
LINE SHDSL interface for WAN port (RJ-11)
RST Reset button for reboot or load factory default
!
The reset button can be used only in one of two ways.
(1) Press the Reset Button for one second will cause system reboot.
(2) Pressing the Reset Button for four seconds will cause the product loading the factory
default setting and losing all of yours configuration. When you want to change its
configuration but forget the user name or password, or if the product is having
problems connecting to the Internet and you want to configure it again clearing all
configurations, press the Reset Button for four seconds with a paper clip or sharp
pencil.