User guide

17
2-5 Debug Settings
generates the debug information based on debug level and modules. Since the
generating debug will consume system resource, it is recommended to turn on only for
Debug
Figure 2-5 Debug setting
Parameter Description:
 SYSLOG: Enable or disable to send system information to SYSLOGD
server or not
 Check for start from Any Time: Always Send: Always send syslog or
only during a specified time range.
 Syslog Start (YYYY/MM/DD HH:MM): Always Send: Always send
syslog or only during a specified time range.
 Syslog Stop (YYYY/MM/DD HH:MM): The syslog stop sending time.
 Syslog Server: Syslog server IP address
 Syslog Port: syslog server service port (default is 514)
 DSP Debug: Enable or disable to send DSP information to capture log
 DSP Capture server: Syslog capture server IP address
 DSP Capture port: syslog capture server service port (default is 50000)
Dynamix 2504 provides the real time debug to syslog or through telnet interface. It
necessary and under Dynamix FAE’s instruction.