User guide

Dynamix DW-E
66
• Primary Outbound Proxy Password: The password of an outbound Proxy
the SIP Stack uses.
• Secondary Outbound Proxy Server: The IP address of an outbound
Proxy the SIP Stack uses.
• Secondary Outbound Proxy Port: The port of an outbound Proxy the SIP
Stack uses
• Secondary Outbound Proxy User: The User ID of an outbound Proxy the
SIP Stack uses.
• Secondary Outbound Proxy Password: The password of an outbound
Proxy the SIP Stack uses.
• Codec Selection Policy: Selection order to match the remote SDP for
codec selection.
o Local SDP Order: Use local SDP order to match codec
o Remote SDP Order: Use Remote SDP order to match codec
• Local Codec 1~4: Codec selection priority (1 to 4) (1: highest, 4: lowest)
• G.723 Bit Rate Used: G.723.1 high bits rate (6.3k) or low bit rate (5.3k) is
used
• 180 SDP: Set SDP for 180 ring message
• 183 SDP: Set SDP for 183 call progress indication.
• DTMF Relay Method: DTMF transport type selection
o Transparent: transmit DTMF over audio channel
o SIP INFO: Use SIP INFO Message to relay DTMF
o RFC2833: Use RFC2833 for DTMF over RTP packet
- RFC2800 Payload Type: RTP payload type used for RFC2833
DTMF relay
• Fax Transmission: Fax transparent type selection
o T.38 Fax Relay: T.38 fax relay
o Transparent: Transparent mode (by voice packet)
• Accept Proxy Call Only:
o Yes: Only call from outbound proxy server is allowed
o NO: Accept any SIP calls
• Inbound DM Group: Digit Manipulation Group for SIP incoming calls
• Outbound DM Group: Digit Manipulation Group for SIP outgoing calls
Advance SIP Configuration:
Start Path: Configuration>SIP >Advance