User`s manual

allows your GW to be connected to an Internet Access

device, e.g. router, cable modem, ADSL modem, through a

networking cable with RJ-45 connectors used on 10BaseT

and 100BaseTX networks.

LAN(Local Area Network) Connect to PC with Ethernet cable. 1 port allows your PC or

Switch/Hub to be connected to the GW through a networking

cable with RJ-45 connectors used on 10BaseT and

100BaseTX networks.

RES(Reset button) Push this button until 3 seconds, and GW will be set to

factory default configuration.

AC power(DC in 12V) A power supply cable is inserted

Call Manager ONLY

Connect the cord to FXS port

Connect the PSTN line to PSTN port

Connect the PBX to phone port

The hardware installation is now complete. The following sections will guide you through setting

up your management PC and connecting to the Web User Interface.