User`s manual

12
Flashing Ring Indication
On Telephone Set is Off-Hook
-------------------------------------------------------------------------------------
6. FXO(Port) Off Line is not enabled
On Line is busy
-------------------------------------------------------------------------------------
6. LCD Panel Off System is Shutdown
On System is Up
NOTE: System initialization will turn some LEDs ON for a few sec.
When System Boot/Reboot , the Port LEDs will flash in turn for a few sec.
1.4.3 Rear Panel Descriptions
L200(GW/GK/SVR) Series
Item Port Description
1 FXS(Foreign Exchange Station) FXS port can be connected to analog telephone sets
or Trunk Line of PBX.
2 FXO(Foreign Exchange Office) Can be Connected to PBX or CO line with RJ-11
analog line. FXO port can be connected to the
extension port of a PBX or directly connected to a
PSTN line of carrier.
3 WAN(Wide Area Network) Connect to the network with an Ethernet cable. This
port allows your ATA to be connected to an Internet
Access device, e.g. router, cable modem, ADSL
modem, through a networking cable with RJ-45
connectors used on 10BaseT and 100BaseTX
networks.
4 LAN(Local Area Network) Connect to PC with Ethernet cable. 1 port allows your
PC or Switch/Hub to be connected to the ATA
through a networking cable with RJ-45 connectors
used on 10BaseT and 100BaseTX networks.
5 RES(Reset button) Push this button until 3 seconds, and ATA will be set
to factory default configuration.
6 AC power(DC in 12V) A power supply cable is inserted