User`s manual
11
ACT
On LAN is connected successfully
Flashing Data is transmitting
Off Ethernet not connected to PC
-------------------------------------------------------------------------------------
5. FXS(Port) Off Telephone Set is On-Hook
Flashing Ring Indication
On Telephone Set is Off-Hook
-------------------------------------------------------------------------------------
6. FXO(Port) Off Line is not enabled
On Line is busy
-------------------------------------------------------------------------------------
7. RES Button Push Push Button until 5 second
Set to Factory Default
-------------------------------------------------------------------------------------
8. RS-232 Console port connect to PC
NOTE: System initialization will turn some LEDs ON for a few sec.
When System Boot/Reboot , the Port LEDs will flash in turn for a few sec.
SB800/S1600/S2400 Series Gateway
------------------------------------------------------------------------------------------
LED State Description
------------------------------------------------------------------------------------------
1. POWER On GW is power ON
Off GW is power Off
------------------------------------------------------------------------------------------
2. RUN port On GW connection established
Flashing Data traffic on cable network
Off Waiting for GW connection
------------------------------------------------------------------------------------------
3. WAN port 100M
On GW network connection 100MB network
Off GW network connection 10MB network
ACT
ON GW network connection established
Flashing Data traffic on cable network
Off Waiting for network connection
------------------------------------------------------------------------------------------
4. LAN port 100M
On GW LAN connection 100MB network
Off GW LAN connection 10MB network
ACT
On LAN is connected successfully
Flashing Data is transmitting
Off Ethernet not connected to PC
-------------------------------------------------------------------------------------
5. FXS(Port) Off Telephone Set is On-Hook