User manual

Dynamix DW-2FXS/2FXO Gateway (H.323) User Manual
means IP side, x means no determinate number.
e164 destination e.164 number. This only need to be set when routed
port is FXS TELs or FXO Lines to determine which port will this call
be routed to.
min minimum digits needed.
max maximum digits needed.
hunt set hunt method for busy forward. 0 means no hunting, 1 means
hunting method follows the rule of [line], 2 means hunting method
is to hunt between all ports in the same type, for example,
destination port is FXS TEL will hunt in all FXS TELs, destination
port is FXO Lines will hunt in all FXO Lines.
Usage Example:
1. route –add prefix 100 dst 0 e164 1001 min 1 max 3 hunt 1
This command means if gateway has incoming call’s prefix number is
100, and total digits is between 1 to 3, this call will be routed to FXS
TEL 1001, and if TEL 1001 is busy, call will be routed to another FXS
TEL.
2. route –ip dst 1 e164 1002
This command means incoming call from IP side will be routed to FXO
Line of number 1002.
3. route –fxs dst 1 e164 1002
This command means incoming call from FXS TELs will be routed to
FXO Line of number 1002.
4. route –fxo dst 2
This command means incoming call from FXO Lines will be routed to
IP side.
Note:
(1) When destination is IP side, e.164 number doesn’t need to
determine. (Ex. route –fxs dst 2)
(2) If user doesn’t want to determine a specific port to route, e.164
number must set as “x”. (Ex. route –ip dst 1 e164 x)
(3) Default value: Incoming call from FXS and FXO ports will be
93