User manual

Dynamix DW-2FXS/2FXO Gateway (H.323) User Manual

file, user can select which hardware type is . ”0” means gateway

will automatically detect the hardware type, “1” means the

hardware type is 1FXS+1FXO, “2” means the hardware type is

2FXS+2FXO.

Note:

The default value is to auto detect hardware type. Usually it is not

necessary to change this setting. Please make sure about your

Hardware Type, Gateway may be not functional if set wrong

hardware type.

-ring ring time for ring detection(in ms). When Gateway has incoming

call from PSTN side to FXO port, Gateway will determine it is a ring

but not noise only if it is longer than this ring time.

Note:

In Taiwan the ring time of PSTN usually is 1000ms, so if user set

ring time longer that 1000ms, FXO port may not be able to pick up

the call from PSTN side.

-eod It will transfer the DTMF in “#” if users disable the end of dial

function. Users have to press the key pad in “#” if the end of dial

function is enable.

-fxotype It’s for the 2nddial function. Any calls will be two-stage-dialing

if user enable this function.

-rba Users could define the ring time if the calls coming from the PSTN

side. This support 1 to 10 ring times.

4.2.11

[h323]

This command is for H.323 configuration related parameters.

-----------------------------------------------------------------------------------------------

usr/config$ h323

H.323 stack information and configuration

Usage:

-print Display H.323 stack information and configuration.

-mode Configure as Gatekeeper mode or Peer-to-Peer

mode.

-gk Gatekeeper ip address. (0.0.0.0 ~ 255.255.255.255)