User manual

Dynamix DW-2FXS/2FXO Gateway (H.323) User Manual
-gwprefix Drop gateway prefix when call from IP(Keep:0/Drop:1).
-hwtype Hardware type.(Auto:0 / 1FXS+1FXO:1 / 2FXS+2FXO:2)
-ring The ring time for ring detection.(Uint:ms)
-eod End of dial..(Enable:1 / Disable:0)
-fxotype FXO type.(Normal:0 / Force 2
nd
dial:1)
-rba Ring before answer.(For 1~10 )
Example: sysconf -ring 500
usr/config$
Parameters Usage:
-print print out all current settings
-idtime set the duration(in second) of two pressed digits in dial mode as
timed out. If after the duration user hasn’t pressed next number, it
will dial out all number pressed. (1-10 seconds)
-forwardtime set forward time(5-65535 seconds)for FXS Line. If callee
hasn’t answered the call in this time, call will be forward to
assigned number in [line] command. (please refer to [line]
command for forward setting)
-keypad DTMF replay type. When value is “0”, Gateway will transfer DTMF
signal via In-Band type, “1” via H.245 UII Alphanumeric, “2” via
H.245 UII Signal Type, and “3” via Q.931 UserInfo, and “4” via
RFC2833 type. Users can adjust the value according to various
applications.
-prefixsw switch on/off prefix function. If user enables prefix function, once
user dials out, gateway will automatically add prefix number before
number user dialed.
-prefixdisab set disable key (0,1,~9, *) to disable the prefix function in this
current call. For example, if user has set prefix as 100, and
wants to dial out 100123, user can only press 123, to dial out
100123.However, if user wants to dial 123 without prefix, user
can press prefix disable key, for example “*”, user can press “*”,
then dial 123, gateway will dial out 123 without adding prefix.
-usrdefprefix define prefix number.
82