User manual

Dynamix DW-2FXS/2FXO Gateway (H.323) User Manual

4.2.2

[quit]

Type quit will quit the Gateway configuration mode and turn back to login

prompt (in console mode) or disconnect (in TELNET mode).

usr/config$ quit

Disconnecting...

Note: It is recommended that type the “quit” command before you leave the

console. If so, Gateway will ask password again when next user connects to

console port.

4.2.3

[debug]

Open debug message will show up specific information while Gateway is in

operation. After executing the debug command, it should execute

command debug -open as well. One example is demonstrated below.

usr/config$ debug -add h323 vp h323vp

usr/config$ debug -open

In this example, user open debug flags including h323, vp, h323vp.

Parameters Usage:

-status Display the enabled debug flags.

-add Add debug flag.

-- h323 : h323 related information

-- vp : voice related information

-delete Remove specified debug flag.

-open Start to show debug messages.

-close Stop showing debug messages.

4.2.4

[reboot]

After commit command, type reboot to reload Gateway in new

configuration. The procedure is as below: