User manual

Dynamix DW-2FXS/2FXO Gateway (H.323) User Manual
6. Pick up the phone and make sure the call is connect.
7. Hang up the phone which is from PSTN side and Tel 1 port will get the
disconnect tone.
8. When you get the disconnect tone from the phone set of the Tel 1 port,
press <R> and <ENTER> buttons to start recording the disconnect tone.
9. Please hang up the phone if you get the message as below Analizing!!
Please wait a moment…
10. There are three values you will get after analyzing. Please leave the value
which is over 1000 Hz, this is not the frequency of disconnect tone.
11. Please put the frequency in the tone table just follow the command
tone 4 420 680 8 8 25 25 50 50
Example-1
(Make a call from PSTN to FXO port)
usr/config$ record -tone
Press (R) to start record...
(Please make sure that you are already finish the steps 2 ~ 7)
r (Press “Enter” button after you key in “R”)
....................................................................................................
....................................................................................................
....................................................................................................
............
Analizing!! Please wait a moment...
(You coule hang up the call from PSTN if you get this message)
Frequency 1 : 481
Frequency 3 : 621
0.25sec on 0.25sec off
tone 4 481 621 8 8 25 25 1023 1023
111