User manual

Dynamix DW-2/4 FXO SIP Gateway User Manual
Disconnecting...
login:
Note: It is recommended that type the “quit” command before you leave the
console. If so, Gateway will ask password again when next user connects to
console port.
4.2.3 [debug]
Open debug message will show up specific information while Gateway is in
operation. After executing the debug command, it should execute
command debug -open as well. One example is demonstrated below.
usr/config$ debug -add fsm vp
usr/config$ debug -open In this example, user open debug
flags including fsm, vp.
Parameters Usage:
-status Display the enabled debug flags.
-add Add debug flag.
-- fsm: sip related information
-- vp : voice related information
-delete Remove specified debug flag.
-open Start to show debug messages.
-close Stop showing debug messages.
4.2.4 [reboot]
After commit command, type reboot to reload Gateway in new
configuration. The procedure is as below:
usr/config$ reboot
.Attached TCP/IP interface to cpm unit 0
Attaching interface lo0...done
Hardware auto detect...
Hardware Type : 2FXO REAL_MAXCALL=2
HTTPD initialized...
56