User manual

Dynamix DW-2/4 FXO SIP Gateway User Manual

♦ GMT - Configuring the time area for the time display in the Command Line

Interface.

The following is for the PPPoE configuration. (see figure 3.2)

Figure 3.2: PPPoE Configuration

♦ PPPoE User Name - Put the PPPoE connection account in this table.

Please get this info from your ISP.

♦ PPPoE Password - Put the PPPoE connection password in this table.

Please get this info from your ISP.

♦ PPPoE IP Address - After the connection success, this table will show you

the IP address which the gateway got from the ISP.

♦ PPPoE Destination - After the connection success, this table will show you

the default gateway address, which the gateway got from the ISP.

♦ PPPoE DNS primary - After the connection success, this table will show

you the DNS ip address from the ISP.

♦ Reboot After Remote Host Disconnection - Enable this function will make

the gateway restart automatically if the PPPoE connection is disconnected

or the IP address was taken back by the ISP.