User`s manual

6
1.2 Front Panel LED Indicators & Rear Panels
1.2.1 Front Panel LED Descriptions
------------------------------------------------------------------------------------
LED State Description
------------------------------------------------------------------------------------
1. POWER On GW is power ON
Off GW is power Off
-------------------------------------------------------------------------------------
2. WAN port On GW network connection established
Flashing Data traffic on cable network
Off Waiting for network connection
-------------------------------------------------------------------------------------
3. LAN port On LAN is connected successfully
Flashing Data is transmitting
Off Ethernet not connected to PC
-------------------------------------------------------------------------------------
4. Phone Off Telephone Set is On-Hook
Flashing Ring Indication
On Telephone Set is Off-Hook
-------------------------------------------------------------------------------------
5. LINE Off Line is not enabled
On Line is busy
NOTE: System initialization will turn some LEDs ON for a few sec.
1.2.2 Rear Panel Descriptions
1. WAN
The WAN port supports auto negotiating Fast Ethernet 10/100Base-T networks. This port allows
your voice gateway to be connected to an Internet Access device, e.g. router, cable modem, ADSL
modem, through a CAT.5 twisted pair Ethernet cable.
2. LAN 1 LAN 4 (S200/S400 series have 4 LAN Ports, S800 series have one LAN Port)
The LAN port supports 4 10/100Base-T switch hub networks. These 4 ports allow your PC or
Switch/Hub to be connected to the voice gateway through a CAT.5 twisted pair Ethernet cable.
3. Reset
The reset button, when pressed, resets the cable voice gateway without the need to unplug the
power cord.
4. Power
The supplied power adapter connects here. The supplied power adapter converts
110V or 220V AC to DC as required for this device.
5. FXS (Foreign Exchange Subscriber)
FXS port was connected to your telephone sets or Trunk Line of PBX.
6. FXO (Foreign Exchange Office)
FXO port was connected to the extension port of a PBX or directly connected to a PSTN line of
carrier.