User`s manual

17
Bridge Mode:
Select S series Gateway as bridge.
NAT mode:
LAN IP Network Configuration
IP Address: Private IP address for connecting to a local private network
(Default:10.10.10.1).
Subnet Mask: Netmask for the local private network (Default: 255.255.255.0/24).
3.3 VoIP Call Protocol Setup
Step1 : configure VoIP Call Signal Protocols :
User could select H.323 or SIP Protocol, and click “select”
Step2 : configure the numbering with phone/line ports.
Phone Number:
The representation number is the phone number of the telephone that is connected to Phone
port.
Line Number:
Line ports are connected to the extension ports of the PBX system or the PSTN line. They
have a common Line Hunting Group Number. When this number is dialed, the Gateway
system will find a free FXO line connected to PBX. This hunting will skip all busy lines and
absent lines and find only the idle line to the PBX. After the available line is found, you can
hear the dial tone from PBX. After that, you can dial the needed phone number out through
PBX.
Step3: Let GW Register to Gatekeeper/SIP Proxy Server
(If user does not have Gatekeeper/SIP Proxy Server, Please go to Step 4: Outgoing Dialing
Plan)
Gatekeeper IP address: There is a gatekeeper address fields. If this gateway does not want to
register to any gatekeeper, just set value 0 to the primary gatekeeper address.
SIP Proxy Server IP addresses: There is a SIP Proxy Server address fields. If this gateway
does not want to register to any SIP Proxy Server, just set value 0 to the primary gatekeeper
address.
Step 4: Outgoing Dialing Plan
The purpose of “Outgoing Direct Call” setting is to let user create a proprietary dialing plan when