User`s manual

10
Microsoft Windows to ping the router. Click Start -> Programs -> MS-DOS Prompt. A command
mode window will open. Type “ping 10.10.10.1” (default IP of the router) to check the network
connectivity. If both hardware and software are correct, your computer will receive
A response from the router as shown on the next page. If not, verify that the Ethernet cable is
connected to the router properly and the Ethernet port LED on the front panel is lit.
2.3 Using the Web Configurator
2.3.1 Connecting to the Web Configurator via a Web Browser
1. Launch the Web browser. Enter http://10.10.10.1 into the browser Address window and press
the Enter key.
2. An authentication dialog box will open.
3. If this is a first time setup of the router, type “admin” as the User Name and the Password field
as “admin”. Click OK.
4. The Web Configurator Setup Main Menu will open. On the main page “Setup Wizard”, “Advanced
Setup” and “System Information” were displayed.
2.3.2 Overview of the System Configuration
The Setup Main Menu (see above figure) consists of four parts:
1. Setup Wizard
2. Advanced Configuration
3. System Administration
4. 中文設定
The following outlines each configuration menu.