User manual

-ip Change the IP default rule.(1=FXO, 2=IP)
-fxo Change the FXO default rule.(1=FXO, 2=IP)
Example:
route -add prefix 100 dst 1 e164 1001 min 1 max 3 hunt 1
route -ip dst 1 e164 1001
route -fxo dst 2 e164 x
route -modify 1 prefix 100 dst 0 e164 1001 min 1 max 3 hunt 1
route -delete 1
usr/config$
Parameter Usages:
-print print out all routing table information
-add add a routing rule in routing table. User can add less than 50 rules.
(route –add prefix “prefix number” dst “destination port type”
e164 “e.164 number of port” min “minimum digits needed”
max “maximum digits can’t be exceeded”)
-delete delete a routing rule in routing table (route –delete “index of
routing rule”)
-modify modify a routing rule in routing table. (route –modify “index of
routing rule” prefix “prefix number” dst “destination port
type” e164 “e.164 number of port” min “minimum digits
needed” max “maximum digits can’t be exceeded”)
-ip create routing table for incoming call from IP side. (route –ip dst
“destination port type” e164 “e.164 number of port”)
-fxo create routing table for incoming call from FXO Lines. (route –fxo
dst “destination port type” e164 “e.164 number of port”)
prefix prefix of dialed number
dst destination port, 1 means FXO Lines, 2 means IP side, x means no
determinate number.
e164 destination e.164 number. This only need to be set when routed
port is FXS TELs or FXO Lines to determine which port will this call
be routed to.
min minimum digits needed.
max maximum digits needed.
hunt set hunt method for busy forward. 0 means no hunting, 1 means
hunting method follows the rule of [line], 2 means hunting method
92