User manual

this to recognize the called party.
-gkid set GateKeeper name for GateKeeper discovery. When Gateway
send out GateKeeper discovery message will search GateKeeper
with this GateKeeper name. (please refer to -gkdis)
-gkdis set auto discovery function on or off. If this function is enabled and
IP address of GateKeeper is set as 255.255.255.255, LAN Phone
will multicast to search a GateKeeper on network with configured
GateKeeper name (please refer to -gkid); if IP address of
GateKeeper is set, before LAN Phone register to the assigned
GateKeeper, it will send out GRQ(GateKeeper Request) message
with configured GateKeeper name to GateKeeper first.
-ttl to set timer for TTL(Time To Live). Gateway would send RRQ, with
keepAlive, to gatekeeper periodically according to TTL timer.
-rtp to allocate RTP port range—NOT RECOMMENDED. This may be
used when RTP port range conflicts with Firewall policy. (each port
of Gateway use 2 RTP ports)
-gkfind gatekeeper finding port. Port number, which Gateway uses it to
discover a gatekeeper. Default value is 1718.
-gkras to set default gatekeeper RAS port number. Default value, 1719, is
well-known port for RAS communication.
-h225 to specify H.225 RAS port number.
-q931 to specify H.225 signal port number.
-dstq931 to specify destination H.225 signal port number.
-range To allocate port range (1500-65535) Gateway may use it.
-respto Maximum response time out
-connto Maximum connection time out
Note: From –rtp to –conneto commands are for advanced users, please do
not change the default settings if not necessary.
4.2.12 [line]
This command is for configure each line parameters of Gateway.
-------------------------------------------------------------------------------------------------
u
sr/config$ line
Gateway line information and configuration
Usage:
line [-print][-config number [hunt number][hotline number]
81