User manual

usr/config$ ifaddr -sntp 1 10.1.1.1
While 10.1.1.1 stands for SNTP server’s IP address.
-ipchange If the unit is behind the IP sharing device and the IP address
for the WAN port of that IP sharing is using the dynamic IP
address. This function has to be enabled.
usr/config$ ifaddr –ipchange 1
-id This id is for the user name of the PPPoE usage.
-pwd This password is for the user name of the PPPoE usage.
-reboot If the connection disconnected by the ISP, the unit will reboot and
get the ip again.
4.2.8 [time]
When SNTP function of FXO GateWay is enabled and SNTP server can
be found as well, type time command to show current network time.
usr/config$ time
Current time is THU JUL 01 11:46:01 2004
Please make sure about that the SNTP server was configured before you
used this command.
4.2.9 [ping]
Use ping to test whether a specific IP is reachable or not.
For example: if 192.168.1.2 is not existing while 210.63.15.32 exists. Users
will have the following results:
usr/config$ ping 210.54.23.129
Please contact with your vendor before you are using the ipsharing and
ipchange function.
74