User manual

remote side.

 SNTP – Enable the SNTP server registering function if user wants to get

the correct time from the Command Line Interface.

 SNTP Server Address – Enter the correct ip address of the SNTP server or

get the incorrect time from the Command Line Interface.

 GMT – Configuring the time area for the time display in the Command Line

Interface.

 IP Sharing – Enable this function if the gateway is behind the IP sharing

device.

 IP Sharing Server Address – Enter the WAN IP address of the IP sharing

device if it is the fixed ip.

 IP Change – Enable this function if the WAN IP address of the IP sharing

device is dynamic address.

The IP change function could support the GK from us only. Please pay

more attentions about this function if your IP sharing device is using

the dynamic IP address.

 PPPoE User Name – To configure the user name for the PPPoE

connection.

 PPPoE Password – To configure the password for the PPPoE connection.

 PPPoE IP Address – In the PPPoE mode, this table will show the ip

address that this unit gets from the ISP.

 PPPoE Destination – In the PPPoE mode, this table will show the default

gateway address that this unit gets from the ISP.

 PPPoE DNS primary – In the PPPoE mode, this table will show the DNS ip

address that this unit gets from the ISP.

 After Remote Host Disconnection – This unit will reboot and re-connect to

the ISP