User manual

define [prefix] in next command.
Terminal type – device will register as H.323 defined Terminal,
[prefix] command is not necessary.
-dfgw default gateway is applied under Peer-to-Peer mode. User defines
a constant default gateway IP address, then any number dialed if
the number is not listed in phone book table will pass forward to
this IP Address.
-prefix assign Gateway prefix number, as well as the registered number
on the Gatekeeper.
-line1 assign Line1 number.
-line2 assign Line2 number.
-line3 assign Line3 number.
-line4 assign Line4 number.
Note:
User can also set “x” in line number to disable the port. If the port is
disabled, it can only receive calls but not calling out.
Note:
1. Line1~Line4 number must follow the prefix number if device is
configured as Gateway Type. For example, if prefix number is 999,
then the line1 & line2’s number are 9991 & 9992.
2. If Gateway is configured as Terminal Type, each line will register to GK
with it’s own number, prefix number is not needed.
3. No matter in GK or P2P mode, user only needs to dial line number to
reach the local port. For example, in P2P mode, user wants to dial from
FXS TEL1 to FXO Line1, only need to dial number of line2.
-passwd set H.235 security password. If user’s GK need H.235 security
token password to authenticate, user have to input topen
password in this command. (please refer to your retailer of GK for
information about token password if they implement this function in
their GK)
-alias H.323 ID. If in gatekeeper mode, this h.323 ID must be different
from others who are registering to the same gatekeeper.
-display An addition name for special application if the calling party needs
80