User manual

 Master : Follow the result from the MasterSlaveDetermination.

 Caller : Follow the caller side.

It’s only for the special requirement. Please contact with your vendor before

ou confi

ure this.

 Local Generate Ring Back Tone(FXS) – To enable or disable the ring back

tone generation from the local side. Support the FXS type only.

 Gateway Prefix – To keep or drop the prefix number of this gateway. This

only support the Gateway type in the GK routed mode. Please get more

detail useful as below:

The gateway could keep or drop the prefix number if the call is coming from the

ip side and bring the prefix number of this gateway. The usage of this command

is about the one-stage-dialing function. Of course it must work with the Routing

table.

Source Gateway Prefix Receive Transfer

10012345 Keep 10012345 10012345

10012345 Drop 10012345 12345

If the incoming call (From IP side) with the number is 10012345, and the prefix

number of the destination gateway is 100. The gateway will receive 10012345.

But the number it transfer will be 10012345 (Gateway Prefix Keep). The

transfer number will be 12345 if the Gateway Prefix function is enabled.

 End of Dial – To enable or disable the end of dial function. This function key

will be the digit “#”.

 Ring Time(FXO) – It for the ring detection from the PSTN. The ring

detection will be failed if users configure it too long.

 Ring Before Answer(FXO) – This will help the users to answer the calls

from PSTN into this gateway quickly. The call will be connected by one

time ring if users configure this for 1. From 1 to 10.

 FXO type – Users could configure all the calls need the 2

stage dialing or

not.

 Normal : The 1

or 2

stage dialing will depend on the dialing plan

from the users. If user dial the number of the FXO port, that will be the

stage dialing.