User manual

'dspapp', and 'rbpcm'.
Example:
rom -method 1
rom -ftp vwusr vwusr
rom -app -s 192.168.4.101 -f app.bin
Parameter Usages:
-print show versions of all rom files
-app, boot, dsptest, dspcore, dspapp to update main Application program
code, Boot code, DSP testing code, DSP
kernel code, or DSP application code.
-boot2m boot2m parameter let users to upgrade the whole system flash,
including all the firmware that mentioned above. If 2M rom file
update is executed, users have to set again the MAC address of
FXO GateWay or it will cause conflict on Ethernet because the
original MAC address is erased during 2M ROM file upgrading.
Note: To set mac address please key in command setmac:(when key in
MAC address ,press enter each time after key in two characters):
-------------------------------------------------------------------------------------------------
usr/config$ setmac
- enter mac address (xxxxxxxxxxxx):
0001a8002baa
- the mac address is 00 01 a8 00 2b aa
- if mac address is correct,please press 'y' to
setup configuration,else press 'n' to continue
y
-------------------------------------------------------------------------------------------------
-greeting The greeting file can be updated by users. The attributes of sound
file should complied to: µ-law, 8000 Hz , 8 bit, Mono, 7 kb/s
-askpin update ASKPIN sound file. This is the greeting sound that when
asking for pincode.
-s to specify TFTP server’s IP address when upgrading ROM files.
-f to specify the target file name, which will replace the old one.
-method to decide using TFTP or FTP as file transfer server. “0” stands for
106