User manual

User Manual
FXS Gateway Overview
Chapter 3
Initial Configuration
This Chapter covers the basic configuration needed to set up and use the
Dynamix DW FXS Gateway. Refer to the other part describes about individual
fields within screens.
3.1 Initial Configuration Overview
This chapter describes the procedure for the initial configuration of the VoIP
Gateway. Refer to the relevant chapters in this User’s Guide for descriptions of the
fields and buttons within individual screens.
3.2 General Configuration
Dynamix DW - FXS Gateway is with a default IP address of 10.1.1.3 and a subnet
mask of 255.0.0.0.
3.3 Static IP address
Step 1. Configure the IP address of this unit. Click [Network Interface] on the
navigation panel. In the Network Interface screen, type a new IP address, subnet
mask and the default routing gateway (e.g. IP Address: 192.168.13.4, Subnet
mask: 255.255.248.0, Default routing gateway: 192.168.8.254) and click the OK
button.
Figure 3-1 Network Interface
Step 2. Click [Commit Data] on the navigation panel. In the Commit Configuration
Data screen, click the [Commit] button.
- 16 -