User manual

User Manual
FXS Gateway Overview
-hotline Set Hot line information. (Port range: 1~6)
Note:
Hotline feature should be used together with:
$sysconf -service 1 (HotLine service)
Example:
bureau -hotline [phone] 192.168.4.200 999
usr/config$
Figure 21-46 bureau command list
Parameter Usages:
-print: Display current Hotline table.
-hotline: Define Line1 and Line2’s Hotline table respectively. The table is included [Line
number], [destination IP Address] and [destination Port or Number].
For example
1. Destination is a FXS device, 628 is its Line number
usr/config$ bureau -hotline [phone]
User picks up the Line1, and then hears the ring back tone generated from
destination. Of course, 628 are ringing simultaneously.
2. Destination is a FXO device, Port 3 is the one connected to PSTN Line.
usr/config$ bureau -hotline [phone] 82265699
User picks up the Line1, and then hears the ring back tone generated from
destination. Simultaneously, 82265699 numbers is the destination, which is
dialed from Port 3.
(Above FXO example is subject to the FXO configurations, such as 2nd dial ON or
OFF.)
For example:
usr/config$ bureau -print
Bureau line setting relate information
Hot line table
=============================================
Port Destination Address Remote TEL
---------------------------------------------
1 192.168.13.78 629
=============================================
usr/config$
Figure 21-47 bureau –print command list
- 105 -