User manual

User Manual
FXS Gateway Overview
-outpxport: Set outbound Proxy port for SIP-Phone to send message, default value is
5060, if there is no special request of Proxy server, please don’t change this
value.
-prefix: when your username contains alphabets, for example sip1123, then specify the
prefix string as “sip”.
-line1: assign line 1 number.
-line2: assign line 2 number.
–pbsearch: enable/disable phone book search function under Proxy Mode. If user
enabled this function, SIP-Phone will search dialed number in phone book to
see if there is any matched table before send to Proxy server, and if there is a
matched data in phone book, SIP-Phone will make call to related IP address.
-expire: this parameter is used to inform proxy server the valid duration of the
registration information.
-port: SIP local UDP port which uses to listen incoming SIP Messages.
-rtp: Specify the RTP received port number.
Note: One will need to configure port and rtp parameters only when you deploy
two or more sets behind the IP sharing device (Router).
For example:
usr/config$ sip –print
Run Mode : PEER-2-PEER MODE
Prefix string : null
Line1 : 1001
Line2 : 1002
Line3 : 1003
Line4 : 1004
pbook search : OFF
SIP listen port : 5060
RTP receive port : 16384
usr/config$
Figure 21-29 sip –print command list
usr/config$ sip –print
Run Mode : PROXY MODE
Primary Proxy address : 10.1.1.2
Secondary Proxy address : null
- 93 -