User`s manual

Dynamix DW-01Plus/S Gateway User Manual
- 80 -
-pxport: Set Proxy port for Dynamix DW-01Plus/S to send message, default value
is 5060, if there is no special request of Proxy server, please don’t change this
value.
-outpx: Set IP Address or URL address (Domain Name Server must be configured.
Please refer to Network Configure) of outbound Proxy server.
-outpxport: Set outbound Proxy port for SIP-Phone to send message, default value
is 5060, if there is no special request of Proxy server, please don’t change this
value.
-prefix: when your username contains alphabets, for example sip1123, then specify
the prefix string as “sip”.
-line1: assign line 1 number.
–pbsearch: enable/disable phone book search function under Proxy Mode. If user
enabled this function, Dynamix DW-01Plus/S will search dialed number in phone
book to see if there is any matched table before send to Proxy server, and if there
is a matched data in phone book, Dynamix DW-01Plus/S will make call to related
IP address.
-expire: this parameter is used to inform proxy server the valid duration of the
registration information.
-port: SIP local UDP port which uses to listen incoming SIP Messages.
-rtp: Specify the RTP received port number.
Note: One will need to configure port and rtp parameters only when you deploy two
or more sets behind the IP sharing device (Router).
For example:
usr/config$ sip –print
Run Mode : PEER-2-PEER MODE
Prefix string : null
Line1 : 1001
pbook search : OFF
SIP listen port : 5060
RTP receive port : 16384
usr/config$
usr/config$ sip –print
Run Mode : PROXY MODE
Primary Proxy address : 10.1.1.2
Secondary Proxy address : null