User`s manual

Dynamix DW-01Plus/S Gateway User Manual
- 78 -
If after the duration user hasn’t pressed next number, it will dial out all number
pressed (1-10 seconds).
-service: set SIP Phone to be normal mode or under hotline mode.
(sysconf –service 0/1, 0 for normal service, 1 for hotline service.)
-keypad: DTMF replay type. When value is “1”, Dynamix DW-01Plus/S Gateway
will transfer DTMF signal via RTP payload as defined in RFC2833. When the value
is set to “0”, the DTMF type is set as In-band, and 2 for SIP info DTMF.
-faxtype: FAX Payload Type. range: 96~128 inter-used:100,102~105.
-2833type: RFC2833 Payload Type. Range: 96~128 inter-used: 100, 102~105.
-lcdrop: Disconnect Supervision (Loop Current Drop) (ON:1 / OFF:0).
-droptime: Period of Loop Current Drop (ms).
-eod: It will transfer the DTMF in [#] if users disable the end of dial function. Users
have to press the keypad in [#] if the end of dial function is enable.
Note:
User can also define IP address here in P2P mode, once user press “#”,
Gateway will call out this IP address.
-callerid: Support Bell Core, DTMF caller ID and NTT caller ID function. After the
first ring at destination site, device will send line number as caller ID to called site.
-dtmfstart: DTMF Caller ID Start Symbol.
-dtmfstart: DTMF Caller ID End Symbol.
For example:
usr/config$ sysconf -print
System information
Gateway Service : 0
Inter-Digits time : 3
BusyForward : OFF
Keypad DTMF type : In-band
End of Dial Digit : #
Caller ID Type : x
DTMF Caller ID Start Symbol : D
DTMF Caller ID End Symbol : C
RFC2833 Payload Type : 96
FAX Payload Type : 101
Disconnect Supervision : OFF
Loop Current Drop Time(ms) : 500
usr/config$