User`s manual

Dynamix DW-01Plus/S Gateway User Manual
- 65 -
5.3 System Commands Overview
5.3.1 [help]
Press help/man/ ? will display all command list of Dynamix DW-01Plus/S. The following
table lists all of the commands that you can use with the Gateway. Refer to the following
chapters for descriptions of commonly used commands.
This user’
s guide describes commands that are helpful for configuring the
Gateway. Using commands not documented in the user’
s guide can damage the
unit and possibly render it unusable.
Commands with Dynamix DW-01Plus/S Gateway
Command DESCRIPTION
help Input help/man/? to list all command list.
quit Input quit/exit/close to exit telnet connection.
debug Add debug flag and display debug messages.
reboot Reboot local machine.
commit Save all data in Dynamix DW-01Plus/S.
ifaddr Internet address manipulation.
time Show current time.
ping Test if an IP address is reachable.
pbook Phone book information and configuration.
pppoe PPPoE parameters manipulation.
flash Clean all configuration from flash rom.
sysconf System information manipulation.
sip Configure SIP related parameters.
security This command
is used to configure the account information included
username and password obtained from the service provider.
voice Voice information manipulation.
support Special functions support manipulation.
tos Set DSCP values for QOS.
phone Setup of call progress tones and ring (SLIC control).
bureau To set Hotline function which must be under Peer-to-
Peer mode and
switch to hotline service.
rom ROM file update.
auth Set configuration items for "administrator" user.
passwd Password setting information and configuration.