User`s manual

Dynamix DW-01Plus/H Gateway User Manual
- 82 -
Parameter Usages:
- print: Print current h323 related settings
- mode: Alternatives for gatekeeper or peer-to-peer mode (0=gatekeeper mode;
1=peer-to-peer mode). If users select gatekeeper mode, an extra gatekeeper is
needed when Gateway is in operation.
- usr/config$ h323 –mode 1 (peer to peer mode)
- gk: Assign gatekeeper’s IP address when Gateway is in gatekeeper mode.
- algk: Assign second gatekeeper’s IP address as redundancy. If Gateway fails to
register to main GK for 10 times, it will try to register to alternative GK.
- gwtype: Gateway type has two kinds, gateway and terminal. Gateway type: will
register as H.323 defined Gateway; user has to define [prefix] in next command.
Terminal type: will register as H.323 defined Terminal, [prefix] command is not
necessary.
- dfgw: Default gateway is applied under Peer-to-Peer mode. User defines a
constant default gateway IP address, then any number dialed will pass forward
to this IP Address.
- prefix: Assign VoIP Gateway prefix number, as well as the registered number on
the Gatekeeper.
- line1: Assign line 1 number.
- passwd: Set H.235 security password. If user’s GK need H.235 security token
password to authenticate, user have to input open password in this command.
- alias: H.323 ID. If in gatekeeper mode, this h.323 ID must be different from
others who are registering to the same gatekeeper.
- display: An addition name for user to recognize in called site.
- gkid: Set GateKeeper name for GateKeeper discovery. When Gateway send out
GateKeeper discovery message will search GateKeeper with this GateKeeper
name.
- gkdis: Set auto discovery function on or off. If this function is enabled and IP
address of GateKeeper is set as 255.255.255.255, Gateway will multicast to
search a GateKeeper on network with configured GateKeeper name; if IP
address of GateKeeper is set, before Gateway register to the assigned
GateKeeper, it will send out GRQ (GateKeeper Request) message with
configured GateKeeper name to GateKeeper first.
- ttl: To set timer for TTL (Time To Live). Gateway would send RRQ, with keep
Alive, to gatekeeper periodically according to TTL timer, default:60 (0~3600
second).
- rtp: To allocate RTP port range—NOT RECOMMENDED. This may be used
when RTP port range conflicts with Firewall policy (1024~65532).