User`s manual

Dynamix DW-01Plus/H Gateway User Manual
- 78 -
usr/config$ sysconf
System information and configuration
Usage:
sysconf [-print][-idtime digit][-forwardtime digit][-keypad used]
[-prefixsw used][-prefixdisab used][-usrdefprefix digits]
[-codec used][-reverse used][-localrbt used][-roundtrip used]
[-gwprefix used][-eod used]
sysconf
-print Display system overall information and configuration.
-idtime Inter-Digits time (1~10 sec).
-forwardtime Forward time for FXS line if no answer (5~65535 sec).
-keypad Select DTMF type: 0=In-band, 1=H.245 Alphanumeric,
2=H.245 SignalType, 3=Q.931 UserInfo, 4=RFC2833.
-prefixsw User defined local zone prefix switch (0=OFF, 1=ON).
-prefixdisab Local zone prefix disable character (one character
from 0~9, *, or NONE('-' key)).
-usrdefprefix User defined local zone prefix (0 ~ 20 digits).
-codec Codec select method (0=Caller, 1=Master).
-reverse Reverse.(0=Disable, 1=Enable).
-callerid caller ID.(0=Disable, 1=Enable).
-localrbt Local ring back tone (0=Disable, 1=Enable).
-roundtrip Disconnect no connect in line busy.(0=Disable, 1=Enable).
-gwprefix Drop gateway prefix when call from IP (0=Keep, 1=Drop).
-eod End of dial (0=Disable, 1=Enable).
-dPSTN FXS dial *# and change to PSTN side(0=Disable,1=Enable).
Example: sysconf -idtime 5
Parameter Usages:
- print: Print current sysconf settings.
- idtime: Set the duration (in second) of two pressed digits in dial mode as timed
out. If after the duration user hasn’t pressed next number, it will dial out all
number pressed (1-10 seconds).
- forwardtime: Set forward time (5-65535 seconds) for FXS Line. If call hasn’t
answered the call in this time, call will be forward to assigned number in [line]
command. (Please refer to [line] command for forward setting.)
- keypad: Select DTMF replay type (0=In-band, 1=H.245 Alphanumeric, 2=H.245
SignalType, 3=Q.931 UserInfo, 4=RFC2833), Users can adjust the value