User`s manual

Dynamix DW-01Plus/H Gateway User Manual
- 51 -
- Forward time: It supports the No Answer Forward function. If users configure it
for 10, the call will be forwarded when it rings about 10 seconds. From 5 to
65535.
- Keypad Type: User could define the keypad for the DTMF sending.
1. In-Band : The DTMF signal sending by RTP.
2. Out-Band : The DTMF signal sending not by RTP. Including
the H.245(Alpha), H.245(Signal), Q.931 and RFC 2833.
- User Defined Prefix Switch: Select on/off for User defined local zone prefix
switch. If user enables prefix function, once user dials out, gateway will
automatically add prefix number before number user dialed.
- User Defined prefix Disable: Disable the defined prefix after press the
selected digit (0,1~9, *).
- User Define prefix: This will be added in the first digits of the numbers that
users had dialed. Can also define IP address here in P2P mode, once user
press “#”, Gateway will call out this IP address.
- Codec Select Method: This could support that the codec will follow the MSD
(MasterSlaveDetermination) or the caller side.
1. Master: Follow the result from the
MasterSlaveDetermination.
2. Caller: Follow the caller side.
- Reverse (FXS): Enable or disable the Reverse signal generation function.
- Local Generate Ring Back Tone (FXS): To enable or disable the ring back
tone generation from the local side.
- Round Trip: The call will be disconnected automatically, if the network is
failed, default value is 10 seconds.
- Gateway Prefix: To keep or drop the prefix number of this gateway. This
only support the Gateway type in the GK routed mode. Please get more detail
useful as below:
- End of Dial: To enable or disable the end of dial function. This function key
will be the digit “#”.
- Dial to PSTN side (162): This function can let user dial out by PSTN. User
just need to press “*#”, the call signal will relay from IP side to PSTN side.
- Detect silence voice (FXO): This function could detect the silence from the
PSTN side. If the FXO detect the silence for 40 seconds continuous, it will drop
the calls. Only support FXO.
- Ring Time (FXO): It for the ring detection from the PSTN. The ring detection
will be failed if users configure it too long. Only support FXO.
- Ring Before Answer (FXO): This will help the users to answer the calls from
PSTN into this gateway quickly. The call will be connected by one time ring if