User manual

DYNAMIX IP PHONE 530. User Manual
36/49
¾ Dial-peer settings
path:<config-pbook>#
[disable]enable calling through GK and proxy ---[no]enableGKandProxy
Add number-IP bond entry ---entry –number xxx –ip x.x.x.x –protocol xxx
Example:<config-pbook>#entry –number 100 –ip 202.112.20.100 –protocol sip
Add number-IP bond and add prefix to the dial number
---entry –number xxx –ip x.x.x.x –protocol xxx _add xxx
Example:<config-pbook>#entry –number 100 –ip 202.112.20.100 –protocol sip _add 123(dial 100
and will send 123100 according this rule)
Add number-IP bond and replace the destination with another number
---entry –number xxx –ip x.x.x.x –protocol xxx _all xxx
Example:<config-pbook>#entry –number 100 –ip 202.112.20.100 –protocol sip _all 123( user dial
100 and gateway will sent 100 instead)
Add number-IP bond and delete the prefix of the destination number
---entry –number xxx –ip x.x.x.x –protocol xxx _del xxx
Example:<config-pbook>#entry –number 1234 –ip 202.112.20.100 –protocol sip _del 2 (dial 1234
will send 34 instead)
Add number-IP bond and replace the prefix with another number
---entry –number xxx –ip x.x.x.x –protocol xxx _rep xxx _length xxx
Example:<config-pbook>#entry –number 1234 –ip 202.112.20.100 –protocol sip _rep 567 _length
2(dial 1234 will send 56734)
Delete dial-peer entry ---no entry –number xxx
Show current dial-peer rules ---show
Set default voip protocol ---default-protocol xxx
¾ Port settings
path:<config-port># 或<config-port X>#
set accecp relay mode ---accept-relay xxx
set callerid mode ---callerid xxx
disable callerid ---no callerid
config call forward ---callforward –conditon xxx –number xxx –ip xxx –port xxx –protocol xxx
Example:<config-port 0>#callforward –condition busy –number 100 –ip 202.112.10.100 -port 5060
–protocol sip
Disable call forward ---no callforward
[disable]enable call transfer ---[no]calltransfer
[disable]enable call waiting ---[no]callwaiting
Set prefer codec ---codec xxx
Set DTMF gain ---dtmfvolume xxx
Set black list ---in-limit xxx
Show black list ---in-limit
Set input volume ---input xxx
Set outgoing limit list ---out-limit xxx
Show outgoing limit list ---out-limit
Set output volume ---output xxx
[disable]enable outgoing limit ---[no]shutdown out
[disable]enable black list ---[no]shutdown in
[disable]enable outgoing limit and black list ---[no]shutdown
[disable]enable 3-way conference ---[no]threetalk
Show port settings ---show
¾ PPPoE settings
path:<config-pppoe>#
PPPoE account settings ---auth –user xxx -password xxx