Specifications

Specifications and Ordering Information
Part Number 162096-01
Rev. F (03/07)
Page 12 of 12
slot so that the I/O module can then be safely removed without
powering down the rack.
More Flexible Mounting Options
In addition to conventional 19-inch rail and panel-
cutout mounting options, the 3500 System
introduces a new bulkhead mounting option,
allowing the rack to be mounted on a wall or other
location where rear access to the rack is not
available.
Enhanced Data
Even without condition monitoring software, the
3500 System is able to provide more measurements
from each transducer channel. For example, in
addition to direct (unfiltered) vibration amplitude for
a radial proximity probe channel, the 3500 monitor
can return gap voltage, 1X amplitude and phase, 2X
amplitude and phase, NOT 1X amplitude, and Smax
amplitude (when XY transducers are present). Thus,
a single radial vibration channel can actually return
8 conditioned parameters (termed proportional
values) for a total of 32 in a single 4-channel monitor
module. This is particularly valuable when
machinery protection strategies require alarms on
these proportional values. Activation or use of these
proportional values has no impact on rack density,
and does not consume additional channels in the
monitor.
Note: ALERT alarm setpoints can be established on each
proportional value, as desired. DANGER alarm setpoints can be
established on any two proportional values returned from each
channel.
Specifications
Consult individual datasheets for each module type.
Ordering Information
Consult individual datasheets for each module type.
Copyright 2002. Bently Nevada, LLC.
1631 Bently Parkway South, Minden, Nevada USA 89423
Phone: [phone] Fax: [phone]
www.ge-energy.com/bently
All rights reserved.
Bently Nevada , System 1, Data Manager, and Keyphasor are trademarks of the General Electric Company.
Modbus is a trademark of Modbus-ADI.