User`s manual

NVF-800S 4-Band VDSL IP DSLAM USER’S MANUAL Ver_B.2
97
4.2.2.4.3 Console Port Information
Console is a standard UART interface to communicate with Serial Port.
User can use windows HyperTerminal program to link the NVF-800S. Connect To->Configure
Bits per seconds:
9600
Data bits:
8
Parity:
none
Stop bits:
1
Flow control:
none
4.2.2.4.4 VDSL Speed Control and port Enable/Disable
This section shows you how to change every port status and speed mode. (Figure 4.69)
Item Description
State:
You can disable or enable VDSL port control
Auto Negotiation:
You can set enable or disable VDSL port
Speed:
You can change VDSL Speed mode by 5Mbps, 15Mbps or 25Mbps. Speed Default Value: Auto-speed
Duplex:
User can set full-duplex or half-duplex mode for Ethernet port. VDSL port fixed on Full Duplex.
Full: User can set flow control function enable or disable in full mode.
Flow Control:
Half: User can set backpressure enable or disable in half mode.
Auto Speed procedures:
a. Confirm the phone cable been connected for both NVF-800S and NVF-200R.
b. Powered on NVF-800S and NVF-200R.