User`s manual

NVF-800S 4-Band VDSL IP DSLAM USER’S MANUAL Ver_B.2
23
making a connection to any of the NVF-800S (L1-L8) station ports. Prepare also 18 ~ 26 gauge twisted pair phone
wiring with RJ-45 plugs at both ends.
3. Connect one end of the cable to the RJ-45 port of the Home Access network adapter and the other end to any
available (1 ~ 8) station port on the VDSL. Every port supports 5/15/25Mbps connections. When inserting an RJ-45
plug, be sure the tab on the plug clicks into position to ensure that it is properly seated.
Caution:
Do not plug a RJ-11 phone jack connector into the Ethernet port (RJ-45 port). This may damage the HPNA. Instead,
use only twisted-pair cables with RJ-45 connectors that conform the FCC standards.
Notes:
1. Be sure each twisted-pair cable (RJ-45) is not over by 100 meters (328 feet).
2. RJ-11 port use 18 ~ 26 gauge phone wiring, 28 gauge or above is not recommended.
3. We advise using Category 5 cable for Cable Modem or router connections or to attach to any high bandwidth device to
avoid any confusion or inconvenience.
3.6 “MDI” Port (TX) Connections
Prepare straight through shielded or unshielded twisted pair cables with RJ-45 plugs on both ends. Use 100Ω
Category 5 cable for connections. Connect one end of the cable to port “9 or 10” of the NVF-800S and the other end to
a standard RJ-45 station port on cable bridge, ADSL bridge, wireless bridge, etc. When inserting an RJ-45 plug, be
sure the tab on the plug clicks into position to ensure that it is properly seated.
Note:
Make sure the length of twisted-pair cable is not over by 100 meters (328 feet).