User`s manual

NVF-800S 4-Band VDSL IP DSLAM USER’S MANUAL Ver_B.2
21
Chapter 3. Complete Installation
3.1 Hardware Installation
This chapter describes how to install the NVF-800S. To established network connection. You may install the NVF-800S
on any level surface (table, shelf, 19 inch rack or wall mounting). However, please take note of the following minimum
site requirements before you begin.
3.2 Pre-Installation Requirements
Before you start actual hardware installation, make sure you can provide the right operating environment, including
power requirements, sufficient physical space, and proximity to other network devices that are to be connected. Verify
the following installation requirement:
• Power requirements: AC 85V to 265 V at 50 to 60 Hz.
Tip:
The Switching power supply automatically adjusts to the input voltage level.
• The NVF-800S should be located in a cool dry place, with at least 10cm/4in of space at the front and back for
ventilation.
• Place the NVF-800S away from direct sunlight, heat sources, or areas with a high amount of electromagnetic
interference.
• Check if network cables and connectors needed for installation are available.
• Do Not install phone lines strapped together with AC power lines, or telephone office line with voice signal.
• Avoid installing this device with radio amplifying station nearby or transformer station nearby.
• Please note NVF-800S internal splitter, can pass through voice spectrum is 0KHz ~ 630KHz.